Hub/Bearing puller for 6 – 8 bolted hubs

Description

A problem solving tool for removing bolted wheel bearing/hub units that are rusted and seized in the wheel knuckle.
In most cases the axle shaft can remain in the hub when the bearing is pulled out. This saves lots of time and is in many cases a must when working with Mitsubishi, Toyota, Nissan, Mazda, Dodge, Chevrolet, GMC Ford (4x4) etc.

Time consuming dismantling, heating and hammering can be avoided altogether. The tool is bolted to the hub with 6/8 bolts using the wheel bolts/nuts from the car. The hub is then pulled out using a bearing puller 01-00046 directly from the car without extra dismantling. The bearing is pulled out quickly and easily with up to 22 ton.

Bolt diameter: 6 bolt 111.5 – 142.5 mm, 8 bolt 162.5 – 182.5 mm.
The M22 carriage beams in the set connects the tool to any of the following cylinders; 01-00030 or 1090-02-WAL.


Contains these parts:
1. 01-00045-001 - Hub plate 6/8 bolt
2. 01-00040-002 - Carriage beam M22, 90 mm
3. 01-00042-003 - Carriage beam M22, 10.9, 121 mm